| Molded
Case - Sturdy, injection molded plastic case designed for the complete
Marine-Sat system (including the receiver) and all accessories. The 'Satellite In A
Suitcase' - Ideal for any kind of travel. Model:MS2MC01 Price: $40.00 |
 |
Fixed Mount
- For your favorite place on the piling, dock or radar arch. Secure with screws provided
and insert Adjustable LNB Feed Arm or Stainless Extension Arm. Model:MS3FM01 |
 |
| Coaxial Cable - High
grade RG-6 Coaxial Cable is critical to quality performance from your DSS system. Use of
low grade cable will cause the picture to digitize. Model:
MS4CB24 - 24 ft. Price: $25.00 |
 |
Directional
Compass - Align Marine-Sat dish with satellite azimuth as determined from DBS
receiver. Use in conjunction with Marine-Sat's Signal Strength Meter for peak performance.
Model: MS4CP01 |
 |
| Multi-Clamp
Mount - Secure on a rail or other horizontal surface and place the LNB support arm
into the Clamp and tighten the lock knob. To use the
Multi-Clamp on a mast or vertical surface, you will need the Extension Arm - Model:
MS3XA01 (sold separately). Model: MS3MC01 |
 |
Stainless
Steel Extension Arm Place into the Multi-Clamp or Fixed Mount (sold separately)
and tighten the lock knob. Ideal for those hard-to-get locations. Model: MS3XA01 |
 |
| Molded Plastic Dish
Antenna - Heavy, reinforced molded plastic dish collects and reflects the RF frequency
from the satellite to the LNB. Model: MS1PD01 |
 |
Signal
Strength Meter - Align the Marine-Sat antenna to the correct satellite frequency with
utmost accuracy. A precision instrument. Model MS4SM01 |
 |
| Marine-Sat LNB Module
- Consists of the LNB (down converter), the LNB Adapter and the LNB Bracket and mounts on
the Adjustable LNB Feed Arm where indicated. Multiple receivers require Dual Feed LNB
Module. Model: MS1LN02(dual) Price: $40.00 |
 |
Marine-Sat
Suction Mount - Place on a smooth, horizontal surface. Rotate
the 3 lock knobs clockwise to create maximum adhesion to the surface. Not designed for
installation on vertical surfaces. Model MS3MS01 |
 |
| Manual Satellite Finder
- Manually align the satellite dish using the azimuth indicator and the elevation level.
For both DSS and Dish Network reception. Model: MS4MM01 |
 |
Adjustable LNB
Feed Arm - Connect the dish antenna and LNB module together and it's ready for mounting in any
of Marine-Sat's 3 mounts best suited for your location. Model:
MS1LA01 |
 |
| AzTrax Rail
Mount Base Clamp - Mount your Marine-Sat AzTrax Unit on your railing. Fits railings 7/8" to 1" diameter. Mount for 1" to 1 1/4" rails also available.
Model: MS3RM01 |
 |
AzTrax Adjustable Rod Holder Mount - Mount your Marine-Sat AzTrax Unit in your existing Rod Holders. Fully adjustable - stainless steel. Model: MS3RH01 |
 |
2 Oakwood Boulevard
Suite 195
Hollywood, FL 33020
In Florida 954-922-9585
Toll Free 800-831-9818
FAX 954-925-1033
info@geosatsolutions.com
Copyright © 2007 GEOSat Solutions, Inc
Information in this document is subject to change without notice.
Other products and companies referred to herein are registered or trademarks of their respective companies or trademark holders.